Categories: Power Amplifier

1.4W Stereo Power Amplifier Circuit based TDA8552

A few more words on the chip. This is a bridge amplifier class AB integrated into the protection against overheating, short circuit protected outputs, suppression of inrush current when you turn on and off the amplifier. The only difference – a little more power output – 1.4 watts per channel. But nevertheless, it also does not require a heat sink and can be used anywhere.

On this chip there is a difference in the headphone sense pin pin number 4. This will detect when a headphone jack inserted into the connector. For more information see the datasheet here.

Parts list :

Components Value
C1 0.33
C2 0.33
C3 0.1
C4 0.1
C5 220uF/10V
C6 220uF/10V
C7 220uF/10V
C8 220uF/10V
C9 0.1
R1 2.2 k
R2 2.2 k
R3 1K
R4 1K
DA1 TDA8552
Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago