200W Mono / Stereo Power Amplifier using TDA1514A

This is circuit design of 200W mono / stereo power amplifier using TDA1514A. This circuit support mono and stereo channel. Mono channel uses bridge configuration, so the mono choice will be give power output by twice than stereo choice.

A symetrical power supply (dual polarity) is required to powered this circuit. Power supply voltage (+) 28VDC and (-) 28VDC max.

The components list and assembling procedure of this 200W mono / stereo power amplifier  is provided in circuit manual document. You may download the circuit manual at the end of this post.

Circuit Features:

  • Universal, robust and compact are the words to describe this amplifier.
  • A stereo or a mono amplifier.
  • Three selectable input sensitivities.
  • Overload and short-circuit protection.
  • Protection against incorrect power supply polarity.
  • Thermally protected.
  • Speaker transient suppression.

Amplifier Specifications:

  • Rms output power: 2 x 50W / 4ohm ; 2 x 40W / 8ohm
  • Rms mono-bridged power: 100W / 8ohm
  • Total music output: 200W
  • Harmonic distortion: 0.01% at 1kHz
  • Signal-to-noise ratio: 102dB (A weighted)
  • Stereo channel separation: 85dB
  • Damping factor (at 100Hz): > 1000
  • Input impedance: 22Kohm
  • Input sensitivity: 300mV, 550mV or 1V switchable
  • Thermal protection: max. 1h
  • Short-circuit and overload protection: max. 10 sec.
  • Power supply: + 28VDC and – 28VDC max.
  • Consumption (2 x 4ohm or mono-bridge 8ohm): 4A max.
  • Consumption (2 x 8ohm): 2.5A max.

Downloads:
[wpdm_file id=1]
[wpdm_file id=2]

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago