Categories: Power Amplifier

1000W Power Audio Amplifier

This is 1000W power amplifier circuit built using many power transistors. The following scheme diagram is used for single/mono channel only, you may build two same circuit for stereo audio system.

Circuit Diagram:

The power supply needed for this circuit should be 10A minimum single channel and 20A for stereo channel. It uses symmetrical power supply (dual polarity) with recommended voltage is 63V.

Component List:

The power transistors 2SA1216 and 2SC2922 must be mounted on heatsink to prevent overheating which will affect to the sound performance and make the transistors damaged faster than normal condition.

Loudspeaker Combination:

To get the speakers with great power combining techniques can be used in parallel series, combining each group of speakers should sepaker they will have the same impedance, the same type (Woofer, Mid Range or tweeter) and the same power. Make sure the volume level adjusted in lowest position when make a trial of this 1000w power audio amplifier.

Amplifier Circuit

View Comments

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago