Categories: Power Amplifier

2.6W Two Channel Amplifier based MAX9751

This amplifier circuit based MAX9751 IC which work on the 5 Volt voltage, unipolar, and a 2.6 Watt power output per channel. In addition, there is a headphone output with separate amplifier and the input selector inputs – you can connect two sources of signal.

Characteristic :

Supply voltage : 4,5V-5,5V
Supply current absence of a signal : 14mA
Output power (max) : 2.6W
THD (P = 1W, RL = 4 Ohm) : 0.02%
S / N ratio : 90dB
Frequency range 22-22000Hz

A few more words on the chip. This is a bridge amplifier class AB integrated into the protection against overheating, short circuit protected outputs, suppression of inrush current when you turn on and off the amplifier.

Parts list :

Components Value
C1 1uF
C2 1uF
C3 1uF
C4 1uF
C5 1uF
C6 1uF
C7 1uF
C8 1uF
C9 0.1
S1 Anyone with a fixation
XS1 Headphone jack – depends on the headphones
DA1 MAX9751

Datasheet can be downloaded here.

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago