Reducing the cost and availability of high-bit ADC and digital signal processors have contributed to the emergence of high power amplifiers, D-class, based on pulse-width modulation. Work output transistor stages in a key mode of such amplifiers allows a few, sometimes dozens of times to increase efficiency, thereby reducing heat generation amplifier, its size and cost. Among all the audio amplifier device class D are the most cost-effective, thanks to the use of digital signal processing. It eliminates the possibility of distortion and noise in the pre-amplifier paths, streamlines and simplifies all kinds of linear and nonlinear signal conversion without using mechanical adjustment components, extends the functionality.
Frequency response, Hz | 10 … 40 000 |
---|---|
Power Output | 235 (RLoad = 4 ohms, THD <0.15%) 315 (RLoad = 4 ohms, THD <10%) 125 (RLoad = 8 ohms, THD <0.09%) 220 (RLoad = 6 ohms, THD <10 %) |
Load resistance, Ohm | 4 … 16 |
The range of volume, dB | -100 … 17 |
Nominal input voltage, V | 1 |
Sampling frequency input signal, kHz | 96 |
S / N ratio, dB | -99 |
Total harmonic distortion + noise, dB | -93 |
Current consumption in standby mode, not more than, mA | 10 |
Nominal input voltage, V | 1 |
Power supply circuit “+50” in | + (50) |
Power supply circuit “+12” stabilized, | 12 |
Master Kit :www.rlocman.ru
Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…
This is the circuit diagram of active antenna amplifier for FM radio device. With only…
This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…
This is the circuit diagram of 150W power amplifier which built using power transistors. The…
This is the circuit design of 1000W stereo audio amplifier. It is a very good…
This is the circuit design of 150W car audio amplifier. The circuit is divided in…