Below is a circuit diagram of class B 15 Watts audio amplifier is designed using a dual op-amp and transistor.
Dual operational amplifier in the LM833 IC is used here. IC1a is wired as a buffer and C3 works as input decoupling capacitor DC. IC1b is wired inverter mode and it provides a negative feedback. Complementary power transistors TIP41 and TIP42 are wired in Class B push pull system and they drive the speaker. Diode D1 provides a bias voltage of 0.7 V in pair of push-pull and capacitors C2 protect 0.7 V bias voltage through D1 from heavy surge voltage at the output of IC1b.
Notes:
The audio amplifier circuit should be mounted on good quality PCB.
Use a support for mounting IC1.
Use a 12 /-12V dual power supply to supply the amplifier.
Potentiometer R2 can be used as a volume control.
Increase the supply voltage will increase power output.
Anyway notefollowing points.
TIP42 and 41 can only handle up to 6A.
IC1 maximum supply voltage can handle is 16/16 V DC.
Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…
This is the circuit diagram of active antenna amplifier for FM radio device. With only…
This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…
This is the circuit diagram of 150W power amplifier which built using power transistors. The…
This is the circuit design of 1000W stereo audio amplifier. It is a very good…
This is the circuit design of 150W car audio amplifier. The circuit is divided in…
View Comments
max. power is about 7.5 w at 8 ohm. Impossible to get more sine output w. +/- 12 v.
At 12 ohm max. is 5w. P max. = (V-vsat)^2/8R.