The input IN is connected to the output of the receiver, U output is connected to the speaker as shown on car audio amplifier scheme. It is very important to ensure that the speaker has no connection tothe chassis (ground) if not, the integrated circuit IC1, a TDA 2004 will soon be damaged. For mounting, carefully follow the implementation of the car audio amplifier scheme for the components. The power supply will keep with 12 volts.
Parts list :
All resistors are 1/4 watt unless otherwise stated.
R1 = 100 Ohms
R2 = 1.5 Kohm
R3 = 180 ohms
R4 = 470 ohms
R5 = 10hm
R6 = 10hm
Cl = 0.1 pF pol.
C2 = 1000pFceramique.
C3 = 10uF / 16Velec.
C4 = 0.1 uFpol.
C5 = 0.22 uF pol.
C6 = .22 uF pol.
C7 = .22 uF pol.
IC1 = TDA2004
A heat sink
Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…
This is the circuit diagram of active antenna amplifier for FM radio device. With only…
This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…
This is the circuit diagram of 150W power amplifier which built using power transistors. The…
This is the circuit design of 1000W stereo audio amplifier. It is a very good…
This is the circuit design of 150W car audio amplifier. The circuit is divided in…