This is a 20 watts audio amplifier is supplied with a voltage 14.4 volts, giving a total power of 20 watts into two different channels, each of which is connected to the tweeter and a woofer. This amplifier is therefore equipped with an active CROSSOVER  filter with a crossover frequency of 2 KHz. Each loudspeaker must support a power of 10 watts and have an impedance of 4 ohms.

The supply voltage can be between 12 and up to 15 volts. This two way amplifier can also be beneficially used as a BOOSTER for 2 way radio. In this case, it is necessary to place a 3.3 Kohm resistor between the output of the radio and the amplifier input (see diagram). To avoid unpleasant distortion, we must avoid to apply input signals greater than 50 mV.

LIST OF ELECTRONIC COMPONENTS:
All resistors are 1/4 watt unless otherwise stated.
Rl = 680 Ohms
R2 = 10Kohms
R3 = 1 Kohm
R4 = 1 Kohm
R5 = 10Ohms
R6 = 10 Ohms
R7 = 10hm
R8 = 1 Ohm
TR1 = 10 Kohm trimmer
CI = 5.6 nF ceramic.
C2 = 5.6 nF ceramic.
C3 = 2.2 uF16V elec.
C4 = 2.2 uF16V elec.
C5 = 2.2 uF16V elec.
C6 = 100uF16V elec.
C7 = 100uF16V elec.
C8 = 100uF16V elec
C9 = 100nF pol.
C10 = 100nF pol.
C11=100nF pol.
Cl2 = 2200uF16Velec.
IC1 = TDA2004-2005
A heat sink

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago