Categories: Power Amplifier

10W Amplifier for portable cd players

This 10W Amplifier is ideal to drive medium size speakers and use it for a portable CD player or mp3 player. With only one active component of TDA2003 integrated circuit and a single supply source of 8 to 18 volts, this amplifier circuit can provide up to 10W of power to the load which can be between 2 and 8 ohm.

Clearly an integrated circuit, TDA2003, must be mounted with the proper heat sink to prevent damage to internal components from overheating.

At full power the circuit requires 2A to work properly.

10W power can be obtained optimally with 12V 2A and 4 ohm loads. These input must be at least 1Vpp to achieve this performance.

10W Amplifier Parts list :
Resistors :
100K variable
47 ohm
220 ohm
2.2 ohm
1 ohm
Capacitors :
2.2uF
470uF
47nF
100nF (2)
1000uF
IC : TDA 2003

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago