50 watt Mosfet amplifier circuit Output is connected to a speaker using inductor L1. Combination network of C5 and R15 are intended for noise reduction. Capacitors C6 and C7 are power supply filter. R6 is set to adjust the quiescent current.
50 watt Mosfet amplifier Parts list :
R1, R12 : 4.7K
R2 : 47K
R3 : 15 K
R4 : 1.2K
R5 : 47K
R6 : 1K var
R7 : 820 ohm
R8 : 10K
R9 : 680 ohm
R10, R11 : 2.7K
R13 : 560 ohm
R14 : 2.2K
R15 : 10 ohm 2W
C1 : 220pF
C2, C3 : 47uF
C4, C6, C7 : 100uF
C5 : 68nF
D1 : 1N4002
Q1, Q2 : BC556
Q3, Q4 : BC546
Q5 : IRF530
Q6 : IRF9530
K1 : 8 ohm
Note:
Assemble the circuit on a good quality PCB.
Use the + /-35V DC dual power supply to power the circuit.
To make the L1 12turns enamelled copper wire on a diameter of 1 cm
C6 and C7 should be 50V; other electrolytes can be 10 or 15V.
Heat sink is required for the MOSFET. A 8x4x4 inch finned heatsink.
Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…
This is the circuit diagram of active antenna amplifier for FM radio device. With only…
This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…
This is the circuit diagram of 150W power amplifier which built using power transistors. The…
This is the circuit design of 1000W stereo audio amplifier. It is a very good…
This is the circuit design of 150W car audio amplifier. The circuit is divided in…
View Comments
Is it output short protected?