Categories: Power Amplifier

30W, 4 channel car amplifier

This 4 channel car amplifier comprises only with a single TDA7386 integrated circuit and a few additional components, four independent amplifier channels to build a true multi-channel audio system. Based on the chip was originally designed for car audio, but this amplifier is also ideal for computers with a sound card as the SoundBlaster Live! Creative Labs Inc or Diamond Multimedia Monster Sound / S3.

As seen in the design, the only active component is an integrated circuit TDA7386, SGS-Thomson. It provides four channels of amplification from a 12v source. The DC input is blocked from 0.1μF capacitor. STBY mute control terminal and may or may not be implemented, is up to you. Output is symmetrical, so there is no speaker terminal is grounded (both amplified).

Cooling:
Heatsink should be enough to keep the chip in the appropriate temperature. You can use a Pentium III with a cooling fan.It is sufficient to connect to Vcc as used 12v like the amplifier.

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago