This Audio booster circuit is very simple and can be applied to fm tuner or audio pre amplifier. The 2N3392  is a low-noise type transistor in TO-92 case. The transistor can can be replaced by a NTE199 or ECG199. If you wish to use a TUN, cross reference the parameters with one of the units from this list : TUP-TUN

Potentiometer R5 of 100K is a linear type with an on/off switch attached. The value of C1 may need to be between 0.05µF and 0.1µF (47nF/100nF). Experiment with the value for best performance.

Parts list :
R1 : 47K
R2 : 470K
R3 : 10K
R4 : 560
R5 : 100K potmeter+switch Linear
R6 : 270
C1 : Capacitor, .05-.1μF Ceramic, 50V
C2 : Capacitor, 0.1μF Ceramic, 50V
C3 : Capacitor, 33μF/25V Electrolytic
Q1 : 2N3392 Transistor, NPN
LED1 LED, red 276-033 Ultra-Bright
Amplifier Circuit

View Comments

  • Can you put also the PBC layout and components layout? You can surely help me about this because it's my project and I'm new to this.

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago