This type of 80w power amplifier circuit chip is ideal for surround sound systems. Since this is quite compact and can be used for independent amplifier for each speaker. In this way it can be upgraded to share source to support all of the connected amplifier.
List of components of 80w power amplifier with tda 7294:
Resistors 1/4 watt 5% unless stated other value
R1-22K
R2 680
R3 22k
R4 47k
R5 100k
R6 27k Ohms – Red, Violet, Orange, Gold-value non-commercial use 22k + 5.6 k in series
R7 2.2 ohm 2 watt Red, Gold, Gold
Capacitors
From C1 1μF 100V – Capacitor Polyester Film
C2 47μF 50V Electrolytic Capacitor
C3, C4 10μF 63V Electrolytic Capacitors
C5 22μF 50V Electrolytic Capacitor
C6, C8 1000μF to 4700μF 50V 50 V electrolytic capacitors
C7, C9, C10 Polyester -104 100n, 100n or 0.1
Semiconductors
D1 1N4148
IC1 TDA7294V
Connectors
K1 connector for signal input (Line In)
K2 connector for connecting the source
K3 connector to connect key standby Mute
K4 Connector for Connecting the Speaker
Others
J1, J2, J3 Jumper – Pieces of wire
Other printed circuit board, symmetrical source-33V +33 / 3 + 3A, heat sink, etc.
Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…
This is the circuit diagram of active antenna amplifier for FM radio device. With only…
This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…
This is the circuit diagram of 150W power amplifier which built using power transistors. The…
This is the circuit design of 1000W stereo audio amplifier. It is a very good…
This is the circuit design of 150W car audio amplifier. The circuit is divided in…