Categories: Pre-amplifier

Pre Amplifier with low impedance input

Preamplifier circuit diagram shown here has a low impedance input characteristics, therefore is suitable for use with magnetic transducers: dynamic microphones, low-impedance magnetic heads, sensors phone.

Amplification of this low impedance input pre amp is therefore very high, whether to reduce, there should be a trimmer R3 series to 100 ohms. The system can be powered by a voltage of between 9 and 18Volts. for its realization, follow the diagram layout.

LIST OF ELECTRONIC COMPONENTS :
All resistors are 1/4 watt unless otherwise specified.
R1, R2 = 1Kohm
R3, R4, R5, R6 = 10Kohms
R7 = 100Kohms
R8 = 100Kohms
Cl = 100uF 16V elec.
C2 = 10uF 16V elec.
C3 = 4.7 uF 16V elec.
C4, C5 = 47uF 16V elec.
T1, T2 = BC237
A 9 volt battery clip.

Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago