Categories: Pre-amplifier

Asymmetric Pre-amplifier Circuit

This Asymmetric Pre amp circuit is designed to amplify a signal little AF stereo line-level, and has an unbalanced input and output. It is perfect to add that little something missing to attack a power amplifier in good condition For example, to slightly increase the output level of a portable player like “MP3” or “FM tuner” supply power single or symmetrical (double), as desired.

Single power supply and virtual ground
The use of a single power supply requires the presence of a voltage equal to the voltage divided by two. This half-voltage is created by the resistors R9 and R10 connected in voltage divider bridge. This half-voltage, which is a virtual ground, is stabilized by capacitor C8 and is brought on the non-inverting input of the op amp by the resistors R5 and R6 to the input signals are superimposed BF

Amplification
The capacitors C3 and C4 are used to limit the DC gain, since a capacitor acts like an open switch for DC voltages The gain is indeed defined by the resistors R1 and R2 for the left channel, and the resistors R3 and R4 for the right way. If the capacitors C3 and C4 do not “lead” not continuous, as if the resistors R1 and R3 were a very high value, as they are “disconnected” For more gain (AC, ie signals with BF), increase the value of resistors R2 and R4. For less gain, decrease in value. With the values ​​adopted here, the gain is about 15 dB (gain of about 5, 12 dB corresponds to a Gainde 4, and 20 dB corresponding to a gain of 10).

Asymmetric Pre amp Output
The AF output is made through coupling capacitors, to avoid passing the half-voltage output of this op amp. The resistors R7 and R9 determine the potential of the negative output capacitors C5 and C6, to a zero potential, so it has no “cloc” when connecting or disconnecting the output preamp, and allow at the same time reduce distortion if the equipment following features input coupling capacitors that are not referenced to ground.

Asymetric pre amp for dual supply voltage scheme.

Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago