Categories: Power Amplifier

10 W Audio Amplifier based TDA 2003

With only one active integrated circuit TDA 2003 as component this circuit can provide up to 10W of audio power to the load which can be between 2 and 8 ohm.

As usual integrated circuit TDA2003, should be placed with which appropriate heat sink to prevent damage to internal components on the temperature of the IC.

10 W audio amplifier circuit requires a current to voltage V max 18VDC 2A to work correctly.

The low power audio amplifier is obtained at the optimal point of the work load of 4 Ω. These entries must be at least 1Vpp to achieve this performance.

10 W Audio Amplifier parts list :

R1 : 100 k potentiometer
R2 : 47 Ω
R3 : 220 Ω
R4 : 2.2 Ω
R5 : 1 Ω
C1 : 2.2 uF
C2 : 470 uF
C4 : 100 nF
C5 : 1000 uF
C6 : 100 nF
C3 : 47 nF
IC1 : TDA2003
4 Ω speaker SPK

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago