Categories: Pre-amplifier

RIAA Stereo Preamplifier Classic Version based on NE5532

This RIAA stereo preamplifier uses only conventional components, you can easily find components at electronics store. The circuit is intended to be used with a vinyl turntable equipped with analog outputs (RCA). It provides the dual function of preamplifier and RIAA correction. This circuit is suitable for a MM (Moving Magnet), and is not suitable for a MC (Moving Coil).

Impedance matching
Left and right inputs performed well on a 47kohm resistor (R2 and R7) that acts as a load resistance for the turntable.

Amplification and RIAA correction
Amplification and RIAA are provided by the NE5532 dual operational amplifier, known for low noise, and related components. There are other integrated circuits perform better than NE5532. Correction frequency following the curve whose shape depends on the value of the resistors and capacitors that are used around the op amp: R3 R5 and C2-C4 for the left channel (upper assembly), R8-R10 and C6-C8 for the right channel (the bottom of the assembly). Amplification (gain) is defined by the voltage on the resistor value.

The supply
The power supply must be symmetrical + / 9V to + /-15V (max + /-18V). Local decoupling is provided by the RC network consisting of R11, C7 and C8 positive for power lines, and R12 C9, C10 to the negative line. For this coupling to be effective, four decoupling capacitors should be placed closest to the pin of the power IC NE5532 (terminals 4 and 8).

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago