Categories: Audio Amplifier

Headphone Amplifier based MOSFET

Here the schematic diagram of headphone amplifier which built based single MOSFET as the main amplification component. This circuit is quite simple and easy to built with minimum cost.

Circuit notes:

  • The MOSFET type is IRF610.
  • The above diagram design is for one channel only, just build the same circuit in one PCB to make it stereo channel.
  • All resistor wattage is 0.25W except the resistor around LM317 which is 0.5W
  • Connect signal ground to the power supply ground. If there is a hum, try connecting with a resistor parallel with capacitor.
  • Use regulated power supply 10-12VDC

The amplifier concept is simple and follows a typical single-ended class A circuit utilizing an active constant current source (CCS) in place of a passive resistor. A CCS doubles the efficiency of the circuit over that where a passive load resistor is used, bringing it to a maximum of 25%.

Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago