Categories: Other Amplifier

Microphone Amplifier based K548UN1

The operating principle is as follows:
Resistors R1, R3 is used to adjust the gain, which equals 25. To increase the gain by 75 to build a resistance of 68 ohms. It is not recommended to install too high gain, because it may affect the sound quality, although this depends on the microphone. Capacitors C5 and C6 are used for suppression of feeding.

This circuit has been tried on three microphones, one from SONY, and then two Chinese, everything works! With the correct assembly of the device starts to work immediately, and does not need tuning.

Parts list :
R1, R3 : 220
R2, R4 : 1K5
R5, R6 : 6K2
R7 : 470
C1, C2, C3 : 0.1uF
C3, C4, C7, C8 : 10uF/10V
C5 : 470uF/15V
DA1 : K548UN1
Amplifier Circuit

Share
Published by
Amplifier Circuit

Recent Posts

10-100W Class-D Power Audio Amplifier Using MD7120 MOSFET Driver

Class-D Power Audio Amplifier Using MD7120 MOSFET Driver This is the circuit design of Class-D…

3 years ago

Active Antenna Amplifier For FM Radio

This is the circuit diagram of active antenna amplifier for FM radio device. With only…

5 years ago

400 Watt 70 Volt Amplifier

This is the schematic design of 400 Watt 70 Volt amplifier capable to deliver about…

7 years ago

150W Power Amplifier using Transistor

This is the circuit diagram of 150W power amplifier which built using power transistors. The…

7 years ago

1000W Stereo Audio Amplifier with Transistors 2SC5200 and 2SA1943

This is the circuit design of 1000W stereo audio amplifier. It is a very good…

7 years ago

150W Car Audio Amplifier

This is the circuit design of 150W car audio amplifier. The circuit is divided in…

7 years ago